OIL FILTRATION SYSTEM

• The dramatic reduction in components wear (seals, piston rods, pump, etc).
• A reduction in the incidence of sticking and worn valve components.
• Extended life of in-line oil filters.
• An end to the need to change hydraulic fluid.

Dirt and wear metals will always be present in Hydraulic and Engine oil. The reasons that most fluid changes are done is to get rid of the dirt and contaminants.

Conventional fluid filtration components will filter the fluid down to approximately 10-micron in size. Using the Kleenoil Oil Recycling System you will filter the fluid down to 1-micron in size reducing the chance of wear and ultimately reducing the number of engine failures and rebuilds that would have needed to be performed during the life of the unit.

Water will always be present because of the heating and cooling of components in a machine.

Small amounts of fuel will pass by the piston rings and end up in the oil. Using the Kleenoil Oil Recycling System will remove all water down to less than 0.01%, reducing the formation of sulfuric acid that will cause accelerated wear to components.

Certain components are purposely placed in lubrication oil to make it effective. Some of the additives include dispersants, detergents, oxidation and rust inhibitors, pour-point depressants, metal de-activators and anti-foaming and gelling agents. 

The Kleenoil Onboard Oil Recycling System is installed to filter the fluid whenever there is oil pressure. Once the engine or the hydraulic pump is activated and there is fluid pressure, the fluid is continuously passing through the densely wound filter cartridge. 

The cartridge is wound with pure coniferous long fiber wood pulp paper. This design allows the water to be extracted from the fluid and still allows the larger oil molecules to pass through unchanged. The dirt and wear particles are trapped in the filter giving you a continuous self-contained recycling system. 

Changing the Kleenoil Filter Cartridge requires much less time than what is required to perform a conventional full fluid change. Simply remove the lid from the container, remove the old cartridge and install the new cartridge and seal. 

All this can be performed in less than 10 minutes and without the worry of spilling oil and disposing of contaminated fluids.